Replacement Parts

Replacement rubber feet for kickstand on Vantage Pro2 and original Vantage Pro consoles. Use two per console.

This replacement wind vane for Vantage Pro2 stations includes a brass tip and is compatible with anemometers that have D-shaped vane shafts. To avo...

PCBA (printed circuit board assembly) for wireless Vantage Pro2 and Vantage Pro2 Plus Integrated Sensor Suites, Wirelss Temperature Station (6372)...

Replacement front cover for shelter housing, without solar panel, for cabled Vantage Pro2 integrated sensor suites.

Replacement insulating blanket for Rain Collector Heater.

Replacement battery door for all Vantage Pro2 and Vantage Pro consoles.

Replacement magnet end cap for tipping bucket for rain collector cones in all wireless and cabled Vantage Pro2 and original Vantage Pro stations ma...

Use to adapt standard (inches) rain collector tipping bucket to metric measurements (mm) in all wireless and cabled Vantage Pro2 and Vantage Pro st...

Easily replace the tipping bucket assembly in your rain collector with the more accurate tipping spoon. Reports in inches. Comes with a 40′ (12 m) ...

PCBA (Printed Circuit Board Assembly) for cabled Vantage Pro2 integrated sensor suites. Includes back shelter housing.

Replacement reed switch for rain collector tipping spoon in all wireless and cabled Vantage Pro2 sensor suites. 19” (0,5 m) sensor cable.

Replacement rear cover for Vantage Pro2 and original Vantage Pro consoles. This is the entire back side of the case, including the battery door and...

Replacement base for rain collector cones in all wireless and cabled Vantage Pro2 stations. Does not include tipping bucket assembly.

Replacement rain collector base for Weather Wizard III and Weather Monitor II.

Replacement power assembly for Rain Collector Heater (7720).

Replacement reed switch for rain collector tipping spoon in all stand-alone rain collectors. 40’ (12 m) sensor cable.

Replacement retainer for antenna grommet in back shelter housing.